Function Settings; Setting The Dialing Mode (Tone/Pulse) - Brother MFC4450 Owner's Manual

MFC 4450/OP-US-5.0

FUNCTION SETTINGS

3. FUNCTION SETTINGS
This chapter is included in both the Setup Manual and this Operations Manual. If you
read the Setup Manual first, you may have completed these function settings already.
There are some settings, such as the date and time, you should set on your MFC before
you begin using it. Once entered, these settings will remain in the MFC until you
change them. You can begin customizing the settings by pressing Function on the
control panel. This activates the function mode and On-Screen Programming prompts.
You can complete a variety of settings in this mode.

Setting the Dialing Mode (Tone/Pulse)

Your MFC supports both tone (multi-frequency) and pulse (rotary) dialing. It is
initially set to TONE, so you do not have to change the setting if you use that kind of
line. If you are using a pulse dial line, you can change the setting to PULSE by
following the steps below:
KEYS TO PRESS
1 . Press Function.
2 . Press 6.
3 . Press 1.
After two seconds you will be prompted to
select pulse or tone.
4 . Press Z (left arrow) or X (right arrow)
to find the dialing mode that matches
your telephone line.
Example: PULSE.
5 . Press Set.
6 . Press Stop to return to the date and time.
3 - 1
THE DISPLAY WILL SHOW:
01/01/1999 00:00
O N L I N E
ENTER NO. & SET
6.TEL OPTIONS
1 . T O N E / P U L S E
D I A L I N G : T O N E
SELECT { } & SET
D I A L I N G : P U L S E
1 . T O N E / P U L S E