Brother MFC4450 Owner's Manual page 151

MFC 4450/OP-US-5.0
Open the file "win.ini" by using the "notepad" application. You can find the following
statement in the [windows] section.
[windows]
run=C:/WINDOWS/SYSTEM/WPSIOMON
To disable this function, put a semicolon at the head of above sentence as follows;
[windows]
;run=C:/WINDOWS/SYSTEM/WPSIOMON
Also, You can find the following statement in the [spooler] section.
[spooler]
QP.LPT1=wpslbq.dll
To disable this function, put a semicolon at the head of above sentence as follows;
[spooler]
;QP.LPT1=wpslbq.dll
Then, Open the file "system.ini" by using the "notepad" application. You can find the
following statement in the [386Enh] section.
[386Enh]
device=wpscomd.386
device=wpsljvpd.386
:
:
WPSLPT1=1
To disable the function, put a semicolon at the head of above sentences as follows;
[386Enh]
;device=wpscomd.386
;device=wpsljvpd.386
:
:
;WPSLPT1=1
You must restart Windows
The modification disables the printer status reporting on your PC, however, you will
be able to use MFC 4450 with no further problems.
Graphics or text is missing when the document is printed
This could be caused by your Display Driver software. Contact your reseller and
inquire about the latest Display Driver software. Another solution is to change your
®
Windows Setup Display selection from the current selection to the standard VGA or
SVGA selection; contact your reseller or Microsoft Support if you need help modifying
®
your Windows Display selection or installing new Display Driver software.
TROUBLESHOOTING PROCEDURES
®
to make these modification effective.
14-9