Brother MFC4450 Owner's Manual page 145

Brother multi-function center owner's manual
Hide thumbs Also See for MFC4450:
Table of Contents

Advertisement

MFC 4450/OP-US-5.0
COOLING
PLEASE
COVER
D I S C O N N E C T E D
D
DOCUMENT
MACHINE
M
PRESS
MEMORY
NO
RESPONSE/BUSY
N
TROUBLESHOOTING PROCEDURES
DOWN
WAIT
OPEN
JAM
ERROR
XX
STOP
KEY
FULL
When the temperature of the drum unit or
toner cartridge becomes too hot, the MFC will
pause its current print job and go into cooling
down mode. During the cooling down mode
you will hear the cooling fan running while the
display on the MFC shows COOLING DOWN
and PLEASE WAIT. You must wait and allow
the MFC to resume printing when it is ready.
The top cover or multipurpose sheet feeder
cover was not completely closed. Please check
each of them.
The telephone line was disconnected by the
other party during the communication. Try
calling the other party to see what happened.
Your documents were not inserted properly,
or the documents were not fed properly, or the
documents were too long.
Open the control panel and remove the
documents. (See page 13-6~8.) Then close the
control panel, press Stop and insert the
documents again, adjusting the guides on either
side of the document, and try sending the fax
again.
Original documents should be straight, non-
wrinkled, to be correctly fed. Otherwise, the
documents may occasionally jam.
Turn off the power. Then contact the Customer
Service number listed on page 14-1.
• Press the FF/Cont switch to print the data
remaining in the MFC.
• Reduce the print resolution or reduce the
complexity of your document.
The number you called does not answer or is
busy. Or, you may have reached a number that
is not connected to a fax machine. Check the
number and try again.
14-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

4450 - mfc b/w laser printer

Table of Contents