Parameter Settings - Mitsubishi Electric Q Series Reference Manual

5 PARAMETER SETTINGS

5 PARAMETER SETTINGS
Start parameter settings.
Construct a single
network system?
Yes
5
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
5 - 1
To run the MELSECNET/H, the parameters for the network module loaded to the
programmable controller CPU must be set with GX Developer.
Some parameters must be set, some must be set as appropriate, and some do not
need to be set depending on the network configuration.
The subsequent pages provide lists of parameters settings required for each network
configuration.
No
No
Construct a
redundant system?
Yes
See parameter list (1)
shown in this chapter.
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
No (Construct a simplified redundant system.)
No
See parameter list (2)
shown in this chapter.
Construct multiple
network systems?
Yes
See parameter list (4)
shown in this chapter.
MELSEC-Q
No
See parameter list (3)
shown in this chapter.
5 - 1