Baseband Calibration; General Instructions For Tuning; Uemek Calibration - Nokia RM-94 Service Software And Tuning Instructions

Hide thumbs Also See for RM-94:

Table of Contents

RM-94

3 - Service Software and Tuning Instructions

Baseband Calibration

If the UEMEK or the Combo memory has been changed, the baseband has to be calibrated. It

is only the UEMEK that has to be calibrated for baseband.

• Connect the phone to a PC, which has Phoenix Service Software and a dongle

installed. A JBV-1 box and an FPS-8 flash box are also needed.

• Start Phoenix Service Software and open FBUS connection.

• Select <Scan Product> (Ctrl-R or in menu file < Scan Product>).

• Wait until the phone information is shown in the lower right corner of the screen.

• Set the operating mode to <Local>.

Select "Tuning" and "Energy Management Calibration" in Phoenix menu.

Issue 1 04/2005

Connect the JBV-1 to a external power supply and adjust the

voltage to 12-15 V and limit the current to 0.5 - 3 A.

Connect the JBV-1 with the XCS-4 cable to the FPS-8-box and take

care that the JBV-1 box is properly connected to the PC by the serial

cable.

Attach the phone to the JBV-1 properly.

Connect the phone and the JBV-1 box via the CA-5S cable.

COMPANY CONFIDENTIAL

Nokia Customer Care

Table of Contents