Nokia RM-94 Service Software And Tuning Instructions page 53

Hide thumbs Also See for RM-94:

Table of Contents

RM-94

3 - Service Software and Tuning Instructions

• trigger for spectrum analyzer (gated sweep)

• trigger for oscilloscope

• trigger for power meter (avoid exchanging of attenuator and getting better accu-

racy in power measurements)

Nevertheless, manual tuning is described below. It has to be carried out in all three bands and

both modes (EDGE and GMSK).

Note: TX Power Tuning must be done with a peak power meter, e.g. Anritsu model ML2408A

with Anritsu Peak Power Sensor MA2442A and a suitable attenuator.

The use of the built-in power meter of GSM testers is likely to cause larger errors than the use

of a dedicated power meter and might cause miss tuning so that the phone might be not com-

pliant with the GSM specifications.

Only bold printed values will be tuned. Those values may differ from version to version, please

rely on latest Phoenix version running on your PC.

Set power supply voltage Vcc = 3.6V !

Issue 1 04/2005

COMPANY CONFIDENTIAL

Nokia Customer Care

Table of Contents