Baseband Calibration; General Instructions For Tuning; Uemek Calibration - Nokia RH-37 Series Service Software And Tuning Instructions

Transceivers

Hide thumbs Also See for RH-37 Series:

Table of Contents

Nokia Custome Care

Baseband Calibration

If the UEMEK or the Combo memory has been changed, the baseband has to be cali-

brated. It is only the UEMEK that has to be calibrated for baseband.

•

Connect the phone to a PC, which has Phoenix Service Software and a dongle

installed. A JBV-1 box and an FPS-8 flash box are also needed.

• Start Phoenix Service Software and open FBUS connection.

• Select <Scan Product> (Ctrl-R or in menu file < Scan Product>).

• Wait until the phone information is shown in the lower right corner of the

screen.

• Set the operating mode to <Local>.

Select "Tuning" and "Energy Management Calibration" in Phoenix menu.

Issue 1 07/04

Connect the JBV-1 to a external power supply and adjust the

voltage to 12-15 V and limit the current to 0.5 - 3 A.

Connect the JBV-1 with the XCS-4 cable to the FPS-8-box and take

care that the JBV-1 box is properly connected to the PC by the serial

cable.

Attach the phone to the JBV-1 properly.

Connect the phone and the JBV-1 box via the SCB-3 cable.

Nokia Corporation

Service Sofftware and Tuning Instructions

RH-37

Page 43

Table of Contents