Nokia RM-94 Service Software And Tuning Instructions page 57

RM-94
3 - Service Software and Tuning Instructions Nokia Customer Care
Make sure that the output power for Power Level 0 is equal or lower than 1dB below the satu-
ration output power. Determine the saturation power by setting the DAC Value to its maximum,
for example, adjust the DAC Value to 29.7dBm for Power Level 0 if the saturation output power
is only 30.7dBm.
Due to high gain slope, you have to ensure, that especially the lower power levels meet the
target values and correct them if needed.
Check if all levels match the target values, correct if necessary and then press < Save & Con-
tinue >.
Tx power level tuning GSM1800 & GSM1900 in EDGE mode
On the popped up window, press ok.
The setup should now look like this:
Issue 1 04/2005 COMPANY CONFIDENTIAL 57
Copyright © 2005 Nokia. All Rights Reserved.