Nokia RH-37 Series Service Software And Tuning Instructions page 63

Nokia Custome Care
Select
The setup should now look like this:
Note: Dependent on the Phoenix version also VBAT value is not displayed
The power levels during TxIQ are adjusted automatically. An explicit selection of power level with
RfControls is not necessary.
Connect a spectrum analyzer or GSM tester with the option 'Narrow Spectrum' to the
antenna pads of the phone.
Issue 1 07/04
RF Controls
Operation Mode
RX/TX Channel
TX Data Type
TX Power Level
Nokia Corporation
Service Sofftware and Tuning Instructions
Burst
37
All1
5
RH-37
Page 63