Nokia RH-9 Series Ccs Technical Documentation page 69

CCS Technical Documentation
NORMAL
• Normal user phone state when phone is powered up normally from power key. In
this state all normal activities are allowed.
• Abnormal behaviour, like testing, tunings, etc. are forbidden.
• All software required for calls, games, etc. will be started.
TEST
• TEST-state is for manufacturing purposes
• ADC-calibration can be done (charging related calibrations), charging is disabled
• Phone can
•Receive and create a call
• Phone can't make a normal
•Display updating, e.g. key press is not shown on the display, battery & field
strength bar are not updated
•Ringing tone, e.g. when receiving a call ringing tone is not allowed
•Warning tones, e.g. when illegal key combination is pressed or battery level
goes too low, no warning tone can be generated
• TEST state is entered automatically from POWER-OFF if test battery is connected
LOCAL
• LOCAL-state is for manufacturing, service and R&D -purposes
• Mobile terminal acts as a slave for the service PC
• Server can't start any action from event other than ISI messages
• UI inactive
• Permanent data, including UI data, reading/writing available with ISI messages
through PERM server.
• SW entity must accept the factory set request
• Phone can't receive and create a call (CS in idle)
• Charging not allowed.
LOCAL state is entered automatically from POWER-OFF if service battery is connected.
BSI resistor
0 – 1k
0 – 1k
> 1k
56k - 130k
Issue 1 11/02
Btemp resistor
> 1k
0 – 1k
0 – 1k
> 4k
ãNokia Corporation
System Module & UI
Activated mode when supplied
Local mode
Local mode (Fast start-up)
Test mode (Fast start-up)
Normal mode
RH-9
Page 69