Operating The Controls After Mowing; Transporting The Machine - Toro Greensmaster e1021 Operator's Manual

is responsible for training all operators and
mechanics.
•
Read, understand, and follow all instructions on
the charger and in the manual before operating
the charger. Be familiar with the proper use of the
charger.
Preparation
•
Keep bystanders and children away while
charging.
•
Wear appropriate clothing while charging,
including eye protection; long pants; and
substantial, slip-resistant footwear.
•
Shut off the machine and wait 5 seconds until the
machine has completely powered down before
charging. Failure to do this may cause arcing.
•
Ensure that the area is well ventilated while
charging.
•
Read and follow all precautions for charging.
•
The charger is for use only on nominal 120 and
240 VAC circuits, and is equipped with a grounding
plug for 120 VAC operation. For use with 240 V
circuits, contact your authorized Toro distributor for
the correct power cord.
Operation
•
Do not charge a frozen battery.
•
Do not abuse the cord. Do not carry the charger
by the cord or yank on the power supply cord to
disconnect the charger from the receptacle. Keep
the cord from heat, oil, and sharp edges.
•
Connect the charger directly to a grounding
receptacle. Do not use the charger on an
ungrounded outlet, even with an adaptor.
•
Do not alter the provided power cord or plug.
•
Do not alter the provided power cord or plug.
•
Avoid dropping a metal tool near or onto a battery;
it might cause a spark or short-circuit an electrical
part that could lead to an explosion.
•
Remove metal items such as rings, bracelets,
necklaces, and watches when working with a
lithium-ion battery. A lithium-ion battery can
produce enough current to cause a severe burn.
•
Never operate the charger without good visibility
or light.
•
Use an appropriate extension cord.
•
If the power supply cord is damaged while it
is plugged in, disconnect the cord from the
wall receptacle and contact an authorized Toro
distributor for a replacement.
•
Unplug the charger from the electrical outlet when
not in use, before moving it to another location, or
prior to servicing it.
Maintenance and Storage
•
Store the charger indoors in a dry, secure place
that is out of the reach of unauthorized users.
•
Do not disassemble the charger. Take the charger
to an authorized Toro distributor when service or
repair is required.
•
Unplug the power cord from the outlet before
starting any maintenance or cleaning to reduce
risk of electric shock.
•
Maintain or replace safety and instruction labels
as needed.
•
Do not operate the charger with a damaged
cord or plug. Replace a damaged cord or plug
immediately.
•
If the charger has received an impact, been
dropped, or otherwise damaged, do not use it;
take it to an authorized Toro distributor.
Operating the Controls
after Mowing
1. Drive the machine off of the green, push down
on the handle to raise the cutting unit, release
the clutch bail, disengage the cutting unit, and
shut off the machine.
2. Remove the grass basket and empty the basket
of clippings.
3. Install the grass basket on the machine and
transport the machine to storage.

Transporting the Machine

After mowing, transport the machine away from the
job site; refer to Transporting the Machine Using
Transport Wheels (page 15)
Machine Using a Trailer (page
21
or Transporting the
15).