Toro Greensmaster e1021 Operator's Manual page 7

Figure 4
1. Socket-head screw
2. Belt cover
3. Belt
4. Loosen the idler-arm bolt and rotate the idler
arm (Figure 4) to release tension on the belt.
5. Remove the belt (shown in
6. Remove the nut, pulley, and key
Figure 5
1. Nut
2. Pulley
7. Remove the existing reel driveshaft
g341864
4. Idler-arm internal hex
5. Idler arm
6. Idler-arm bolt
Figure 4).
(Figure 5).
g343494
3. Key
4. Existing reel driveshaft
(Figure 5).
Installing the Reel Driveshaft
1. Install the new reel driveshaft (included in the
loose-parts bag).
Take care to not damage the seal.
1. Nut
2. Pulley
2. Install the key into the driveshaft keyway
6).
3. Install the pulley
4. Use the nut to secure the new reel driveshaft to
the assembly (Figure
5. Torque the nut to 37 to 45 N∙m (27 to 33 ft-lb).
6. Install the belt and tension the belt by applying 4
to 5 N∙m (35 to 40 in-lb) to the idler-arm internal
hex shown in Figure
7. Tighten the idler-arm bolt and use the previously
removed socket-head screws to install the belt
cover.
Adjusting and Installing the
Cutting Unit
1. Use 4 socket-head screws to install the cutting
unit to the machine
7
Figure 6
3. New reel driveshaft
4. Key
(Figure 6).
6).
4.
(Figure 7).
g343495
(Figure