Installing The Battery - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

Installing the battery

The following notes describe information that you must consider when replacing the
battery in the computer:
v When replacing the battery, you must replace it with a lithium battery of the same
v To order replacement batteries, call 1-800-426-7378 within the United States, and
v After you replace the battery, you must reconfigure the system and reset the
v To avoid possible danger, read and follow the following safety statement.
To install the battery, complete the following steps:
1. Insert the new battery:
Figure 28. Installing the battery
2. Reinstall any adapters that were removed.
3. Install the hard disk drive bracket, if one was removed (see "Installing the hard
4. Install the side cover (see "Installing the side cover" on page 76).
type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
system date and time.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or
an equivalent type battery recommended by the manufacturer. If your
system has a module containing a lithium battery, replace it only with the
same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
– Throw or immerse into water
– Heat to more than 100°C (212°F)
– Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket (see Figure 28) until it clicks into
place. Make sure that the battery clip holds the battery securely.
disk drive bracket" on page 97).
Chapter 4. Removing and replacing computer components
93