Installing The Power Supply - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

Installing the power supply

Important:
This computer is suitable for use on an IT powers distribution system, whose
maximum phase to phase voltage is 240 V under any distribution fault condition.
To install the power supply, complete the following steps:
1. Place the power supply into the chassis and slide it toward the rear of the
Figure 53. Installing the power supply
2. Install the power-supply retaining screws from the rear of the computer.
3. Reconnect the cables from the power supply to the system board and all
4. Install the hard disk drive bracket, if one was removed (see "Installing the hard
5. Install the side cover (see "Installing the side cover" on page 76).
6. Reconnect the external cables and power cords; then, turn on the attached
120
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
computer until the power-supply retaining tab clicks into place (see Figure 53).
internal components.
disk drive bracket" on page 97).
devices and the computer.
Retaining tab