Husqvarna Automower 405X Operator's Manual page 39

Message Cause
Stuck in charging sta-
There is an object in the way of the product
tion
preventing it from leaving the charging sta-
tion.
Charging system Incorrect type of battery.
problem
Charging current too Incorrect or defective power supply unit.
high
No power in charging
Incorrect or defective power supply unit.
station
Power failure.
No contact between the contact plates and
the charging plates.
Trapped
The product is stuck in a small area behind a
number of obstacles.
Mower tilted
The product is tilted more than the maximum
angle.
Upside down
The product is leaning too much or has
turned over.
Lifted
The lift sensor has been activated as the
product has been lifted.
Electronic problem
Temporary electronic or firmware related is-
sue in the product.
Loop sensor prob-
lem, front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device
combination
Temporary battery
problem
Safety function faulty
Invalid system combi-
nation
1650 - 003 - 24.02.2021
Action
Remove the object.
Use original batteries recommended by the
manufacturer.
Restart the product. If the problem stays
speak to your authorized service technician.
Examine the power supply. If it is necessary,
replace the power supply.
Find and correct the cause of the power fail-
ure.
Make sure that the charging plates and the
contact plates are connected.
Remove the obstacles or create an island
around the obstacles. Refer to
island on page 17 .
Move the product to a flat area.
Turn the product the right way up.
Check that the product body can move freely
around its chassis. Remove or create an is-
land around objects that can cause the chas-
sis to be lifted. If the problem stays speak to
your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Troubleshooting - 39
To make an