Panasonic KX-TCD725RUM Service Manual page 156

http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s1503060000.html
0F05 15
0F06 28
0F07 3C
0F08 64
0F09 0A
0F0A 4A
0F0B 08
0F0C 14
0F0D 46
0F0E 28
0F0F 82
0F10 82
0F11 FF
0F12 64
http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s1503060000.html (2 of 3)13.10.2007 10:21:51
Cfg-2
MakeTime
BreakTime
DtmfTime
InterDigitDtmfTime
InterDigitPulseTime
CalibBreakTime[0]
CalibBreakTime[1]
CalibBreakTime[2]
CalibBreakTime[3]
CalibBreakTime[4]
CalibBreakTime[5]
LineSeizureEndTime
RingTermToU100
PSTN line configuration 2 (factory settings)
Bit
0: Meter-pulse, 1=enable
1: DialToneMode, dial tone detection 1=enable, 0=
2:BusyToneMode. busy tone detection 1=
0=disable
3: CurrentLimiterMode, 1=enable, 0=
4: RingToneMode. Ring tone detection 1=
0=disable
5:HookRelayEnable, 1=enable, 0=
is used for earth-control EarthBreakEnable and
HookRelayEnable cannot both be set to 1).
6..7: not used
Defaults to 0001 0101B.
D Pulse make time.
Unit : 1 ms. defaults to
D Pulse break time
Unit : 1 ms. defaults to
D DTMF tone pulse time.
Unit : 1 ms, defaults to
D Inter-digit time in DTMF mode.
Unit : 10 ms , defaults to
D Inter-digit time in Pulse mode.
Unit : 10 ms, defaults to
D Calibrated loop-break time for short break
Unit : 10 ms, defaults to
D Calibrated loop-break time for long break
Unit : 10 ms, defaults to
D Calibrated loop-break time for extra-long break
Unit : 10 ms, defaults to
D Calibrated earth-break time for short break
Unit : 10 ms, defaults to
D Calibrated earth-break time for long break
Unit : 10 ms, defaults to
D Calibrated earth-break time for extra-long break
Unit : 10 ms, defaults to 1300 ms.
D Line seizure end-time - time after hook-on. Meter-pulse
detection continues during this period of time. 00h or
FFh means 10 ms.
Unit : 10 ms, defaults to
D Ring terminate time-out period. This is the max time
that must elapse between two ring-voltage bursts
before the new ring-voltage is registered as a new
incoming call.
Unit: 100 ms.defaults to approx
, 0=disable
enable ,
disable
enable ,
disable (if same port
40 ms .
60 ms .
100 ms .
100ms .
740 ms .
80 ms .
200 ms .
700 ms .
400 ms .
1300 ms .
10 ms .
10 sec .
disable