Panasonic GM1 Series Reference Manual page 17

No. Name
RTEX function
Pr7.22 extended setup
1
RTEX function
Pr7.23 extended setup
2
WUME-GM1H-01
2.2 Restrictions on the GM1 Controller and Servo Amplifiers
Description
Use setting value "1 (32-byte mode)".
(Mandatory)
Use setting value "18".
(Mandatory)
This parameter sets each function in bits.
bit 0: Allow parameter values to be written via RTEX
communication
0: Allow, 1: Disallow
bit 1: Set a sub-number for alarm code
0: Fixed at 0, 1: Enable sub-number
bit 2: Set RTEX status response conditions when "Over-travel
inhibit input setup" is disabled (Pr5.04 = 1)
0: Enable status, 1: Fixed at 0
bit 3: Set RTEX status bit assignment for POT and NOT
0: POT corresponds to bit 1 and NOT corresponds to bit 0, 1: NOT
corresponds to bit 1 and POT corresponds to bit 0
0: POT corresponds to bit 1 and NOT corresponds to bit 0, 1: NOT
corresponds to bit 1 and POT corresponds to bit 0
bit 4: Set display mode for "COM" LED
0: Mode 1, 1: Mode 2
bit 5: Set non-cyclic command start mode
0: When a change from base command occurs
1: When command code or command argument changes
bit 6: Set RTEX status logic for POT and NOT
0: Do not reverse, 1: Reverse
bit 7: Set RTEX status logic for PSL and NSL
0: Do not reverse, 1: Reverse
bit 8: Select RTEX status from In_Progress / AC_OFF
0: In_Progress, 1: AC_OFF
(It is linked to the setting in bit 15.)
bit 9: Select whether to return a command error when a
command for motion toward the direction of over-travel
prohibition is received after deceleration stop is executed by
"Over-travel inhibit input setup"
0: Do not return a command error
1: Return a command error
(Bit 10 to bit 13 are not used.)
Fix to "0".
bit 14: Set position deviation [command unit] output
0: Internal commanded position (after filtering) [command unit] -
Actual position [command unit]
1: Internal commanded position (before filtering) [command unit] -
Actual position [command unit]
Standard
factory
default
setting
(Note 2)
1
(Note 2)
18
2-5