Light Shield - Kodak X-Omat 480 RA Processor Installation Instructions Manual

Aligning the Film Guide
[1] Insert a 35 x 43 cm (14 x 17 in.) film into the FILM GUIDE.
[2] Use the edges of the film to align the FILM GUIDE at a 90° angle with the DETECTOR CROSSOVER
ASSEMBLY.
[3] Tighten the 3 WING NUTS.
Installing the Light Shield on Stand-alone Units
[1] Align the holes in the LIGHT SHIELD with the
holes for the 2 SCREWS.
[2] Install the 2 LOCK WASHERS, WASHERS,
and SCREWS through the LIGHT SHIELD
and into the PROCESSOR.
The SCREWS, WASHERS, and LOCK
WASHERS are provided in the
PRE-PACK.
14
FEED SHELF
WING NUT (3)
SCREW (5)
Figure 13 Aligning the Film Guide
NOTE
FILM
GUIDE
DETECTOR
CROSSOVER
ASSEMBLY
Figure 14 Installing the Light Shield
H108_0034BCA
H108_0365BA

LIGHT SHIELD

H108_0268ACA
SCREW (2)
H108_0268AA
1C0932