Hollow Shaft With Splines - Siemens SIMOGEAR BA 2030 Translation Of The Original Operating Instructions

Installation
4.9 Installing and removing the shaft-mounted gearbox
4.9.5

Hollow shaft with splines

*
①
②
③
④
⑤
⑥
⑦
Figure 4-10
Instead of the nut and threaded spindle shown in the diagram, other types of equipment
such as hydraulic lifting equipment may be used.
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft ends and
flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Please contact
Technical Support if you notice any damage.
3. Apply the mounting paste ⑦ to the machine shaft ①. Apply the paste uniformly.
4. Fit the gearbox using the disk ⑤, threaded spindle ④ and nut ③. Support is provided by the
hollow shaft ②.
5. Replace the nut ③ and the threaded spindle ④ with a screw. Tighten the bolts to the
specified torque.
You have mounted the hollow shaft with splined shaft.
Table 4- 11
Thread size
Tightening torque in Nm
52
Not included in scope of supply
Machine shaft
Hollow shaft
Hexagon nut
Lead screw
Disk
Locking ring
Mounting paste
Mounting the hollow shaft with splines
Tightening torque for the screw
M5
5
M6 M8 M10 M12
8 8 14 24
Operating Instructions, 02/2021, A5E37880173A/RS-AM
M16 M20 M24 M30
60 120 200 400
BA 2030