Faults, Causes And Remedies - Siemens SIMOGEAR BA 2030 Translation Of The Original Operating Instructions

Faults, causes and remedies

Note
Faults and malfunctions that occur during the warranty period and requiring repair work on
the gearbox must be remedied only by Technical Support. If faults occur without a clearly
identifiable cause, Siemens AG recommends the services of the Technical Support even after
the warranty period has elapsed.
If you need the help from the Technical Support, please have the following information
ready:
• Rating plate data
• Nature and extent of the fault
• Suspected cause
Table 7- 1
Faults
Unusual noise on
the gearbox.
Unusual noise
from the drive
unit.
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
Faults, causes and remedies
Causes
Oil level too low.
Foreign bodies in the oil (irregular
noise).
Excessive bearing play and / or bearing
defective.
Defective gearing.
Fastening bolts loose.
Excessive external load on the drive
input and output.
Transport damage.
Damage due to blockage during
commissioning.
Drive unit bearing not lubricated
(motor size 160 and higher).
Excessive bearing play and / or bearing
defective.
Fastening bolts loose.
Remedy
Check the oil level (Page 74).
Checking the oil quality (Page 82).
Cleaning the gearbox (Page 98).
Change the oil (Page 74).
Check the bearing and replace if
necessary.
Check the gearing and replace if
necessary.
Checking tightness of fastening bolts
(Page 99).
Check the load against rated data (you
might need to correct the belt tension,
for example).
Check the gearbox for damage in
transit.
Call Technical Support.
Regrease bearing (Page 87).
Check the bearing and replace if
necessary.
Checking tightness of fastening bolts
(Page 99).
7
67