3.2.1 ID Number Menu
SEE ID MENU SELECTION IN CONFIGURATION SECTION FOR
ENABLE/DISABLE OR CHANGE ID CODE.
If ID Code is Disabled or set as Default (0000) the menu will skip ID
step to Setpoint Menu.
If ID Code is set to Full Security Level and user attempts to enter the
Main Menu, they will be prompted for an ID Code.
If ID Code is set to Set Point/ID Security Level and user attempts to
ENTERING YOUR NON-DEFAULT FULL SECURITY ID NUMBER.
Press a
Press d
Press b & c
Press d
ENTERING YOUR NON-DEFAULT SET POINT/ID SECURITY ID NUMBER.
Press a
Press a
Press a
Press d
Press b & c
Press d
To prevent unauthorized tampering with the setup parameters, the
instrument provides protection by requiring the user to enter the ID
Code before allowing access to subsequent menus. If the ID Code
entered does not match the ID Code stored, the unit responds with an
error message and access to subsequent menus will be denied.
Use numbers that are easy for you to remember. If the ID Code is
forgotten or lost, call customer service with your serial number to
access and reset the default to 0000 .
1) Display shows ID .
2) Display advances to ____
3) Press b to increase digit 0-9. Press c to activate next digit
(flashing). Continue to use b and c to enter your 4-digit ID code.
4) If the correct ID code is entered, the menu will advance
to the Setpoint 1 Menu, otherwise an error message ERRo
will be displayed and the instrument will return to the Run Mode.
5) Display shows SP1 Setpoint 1 Menu.
6) Display shows SP2 Setpoint 2 Menu.
7) Display shows ID ID Code Menu.
8) Display advances to ____ .
9) Use b and c to change your ID Code.
10) If the correct ID code is entered, the display will advance
to the INPT Input Menu, otherwise the error message ERRo
will be displayed and the unit will return to the Run Mode.
14