Table of Contents
Advertisement
Chapter 5 Maintenance
Replacing the Developing Unit (continued)
(3) Slide the developing unit to the
left, then pull it out.
3. Install a new developing unit.
(1) Unpack a new developing unit.
(2) Tip the developing unit with the
gear side downward, and shake it
up and down about four or five
times.
(3) Then hold the developing unit in a
level position and shake it from
side to side four or five times.
(4) Remove the protective cover, then
pull off the protective sheet and
the mat in a downward direction.
NOTE:
It is not necessary to keep the
protective cover, the protective
sheet and the mat.
(5) Peel the tape fixing the magnet
tape, then carefully remove the
magnetic tape by slipping it down
slowly.
Protective
cover
Mat
Protective sheet
5-11
Advertisement
Table of Contents
