Turning The Power On - Konica Minolta 1312 User Manual

Chapter 2 Preparations before using the copier

Turning the Power On

NOTE:
Before turning on the power to your Konica 1312 Copier for the
first time check to be sure that the three screws used to fasten
the optical unit and upper unit during transportation have been
removed. (See p. 2-2).
If power is turned on with these screws installed, the copier will
malfunction.
1. The power cord is packed with your
copier. Connect one end of the
power cord to the power supply
connector located on the side of the
copier next to the power switch.
2. Then, insert the other end of the
power cord plug into the wall outlet.
3. Turn the power switch ON.
When the copier is initially turned
on, the code [P26] displays.
After preparing the drum unit and
developing unit, and installing the
toner cartridge, initialize the
developing unit and paper size
before using the copier for the first
time.
(See initializing procedures
starting on the next page.)
2-16
Power plug illustration varies
according to the shipping
destination of the copier.