Zenoah BHT250PD60 Workshop Manual page 17

Note: Hold the parts in position in the handle when you
disassemble it.
1. Carefully lift out the cables, plug (A) and clips (B).
Disconnect the plug.
B
2. Remove the 4 screws and remove the handle from
the chassis.
3. Pull out the handle stop (C) and turn the fastener (D)
1/4 of a turn until it stops.
C
4. Push the plastic catch (E) with a screwdriver until it
goes above the heel. Turn the fastener (D) 1/4 of a
turn until it stops.
620 - 002 - 29.01.2019
A
1 /
4
D
1 /
4
E
5. Use a screwdriver to carefully remove the fastener
from the handle. Then remove it from the cables
together with the O-ring.
6. Remove the 5 screws and remove the right handle
half.
7. Remove the handle stop (F) and the spring (G) from
the handle.
8. Remove the power trigger (H).
H
F
G
Repair instructions - 17