Troubleshooting Of The Battery Connector - Zenoah BHT250PD60 Workshop Manual

Symptom
A green lamp on the charger comes
on for approximately 5-10 seconds
when the battery is attached. After
that a red warning sign flashes on the
charger. This sequence then occurs
again.

6.6 Troubleshooting of the battery connector

6.6.1 To disassemble the battery connector
CAUTION: The pin in the connector of the
communication cable is loose and can fall out.
1. Remove the battery connector.
2. Push out the pins with a screwdriver.
620 - 002 - 29.01.2019
Possible causes
Defective Battery.
Defective charger.
3. Pull out the wires and connectors to the positive and
4. Lift the plastic fastener and pull out the
Recommended step
Put the battery in a charger. If the
same problem occurs, replace the
battery.
Put a battery in the charger. If the
same problem occurs, replace the
charger.
negative terminals.
communication cable, if installed.
Troubleshooting - 23