Zenoah BHT250PD60 Workshop Manual page 24

6.6.2 To assemble the battery connector
CAUTION: The pin in the connector of the wire
is loose and can fall out.
1. Push the communication cable connector into the
plastic housing, if the battery connector has a
communication cable.
CAUTION: Make sure the pin in the
communication cable connector is in the
correct position (A). The product cannot
send information to the common service
tool, if the pin is missing or in the incorrect
position.
2. Put the battery connector with the red wire into the
positive side of the plastic housing. Align the holes
for the pins.
24 - Troubleshooting
A
3. Put the battery connector with the black wire into the
negative side of the plastic housing. Align the holes
for the pins.
4. Push the pins into the holes through the housing and
the connectors.
CAUTION: Make sure that the holes in the
connections align with the holes in the
housing before you push in the pins.
620 - 002 - 29.01.2019