Zenoah BHT250PD60 Workshop Manual page 10

WARNING: The spring can eject and cause
injury. Put on protective goggles.
4. Remove the 10 screws and carefully remove the
handle half.
5. Remove the relay with cables (C) and the loop (D)
out of the handle.
C
6. Lift the start inhibitor (E), the 3 plastic clips (F), the 3
springs (G) and the spring (H) out of the handle.
F
G
H
G
F
5.4.1.2 To assemble the start inhibitor and the front
handle
CAUTION: Make sure that the cables are set
correctly to prevent damage.
10 - Repair instructions
D
G
E
1. Put the start inhibitor (E), plastic clips (F) and
springs (G and H) in the handle.
G
H
G
F
2. Put the relay with cables (D) and the loop (C) in the
handle.
3. Attach the handle halves with the 10 screws.
4. Make sure the safety catch moves to the rear in all
directions.
F
F
G
E
D
C
620 - 002 - 29.01.2019
F