Zenoah BHT250PD60 Workshop Manual page 18

9. Remove they keypad, the main switch and the
cables from the handle.
5.11.2 To assemble the rear handle
WARNING: Make sure that the spring does not
eject out and causes injury. Put on protective
goggles.
CAUTION: The flat cable to the keypad is very
easily damaged.
Note: Make sure that cables and such are set correctly.
It must be easy to put together the handle halves.
18 - Repair instructions
Note: The fastener can only be pressed onto the handle
when the groove and the heel on the handle engage.
Make sure that the O-ring is set correctly in the fastener.
1. Put the keypad, main switch and cables in the
handle. Make sure the cables and clips are set
correctly in the grooves in the handle.
2. Put the power trigger (H) into the handle followed by
the handle stop (F) and spring (G).
H
3. Put the right handle half in position and attach with
the 5 screws.
F
G
620 - 002 - 29.01.2019