Front Handle - Zenoah BHT250PD60 Workshop Manual

503 98 96-03 (20g). The gearbox must not be fully filled
with grease.
• Apply approximately 2.5 g of grease.
1
3

5.4 Front handle

5.4.1 To remove the front handle
CAUTION: Make sure that the cables to the
handle are not damaged when you assemble
the cover.
620 - 002 - 29.01.2019
5
2
4
1. Remove screw (A) and lift off the cover (B) above
the handle cables.
B
2. Remove the 3 screws that holds the handle.
3. Remove the handle and position it by the product.
Make sure that the cables are not damaged.
5.4.1.1 To disassemble the front handle and start
inhibitor
1. Remove the front handle and the right chassis half.
2. Disassemble the gear housing and motor. See
remove the gear housing and the motor from the
chassis on page 11 .
3. Disconnect the handle cables (A) from the control
unit and remove them through the hole (B) in the
chassis.
A
B
A
Repair instructions - 9
To