Power Trigger; Gears - Zenoah BHT250PD60 Workshop Manual

5. Put the cables through the hole (B) in the chassis
and connect the plugs (A) to the control unit.
A
B
CAUTION: Make sure that the safety catch
operates correctly when the plugs (A) are
connected.
6. Assemble the gear housing and motor in the
To assemble the gear housing and
chassis. See
motor in the chassis on page 12 .
7. Assemble the right half of the chassis. See
remove the front handle on page 9 .
8. Attach the front handle in opposite sequence of
disassemble the front handle and start inhibitor on
page 9 .

5.5 Power trigger

5.5.1 To disassemble the power trigger and handle
stop
1. Disassemble the front handle and the right chassis
half. See To remove the front handle on page 9 and
To disassemble the chassis on page 8 .
2. Disassemble the rear handle. See
the rear handle on page 16 .
3. Remove the handle stop (A) and the spring (B).
Remove the power trigger (C).
C
620 - 002 - 29.01.2019
To
To disassemble
A
B
5.5.2 To assemble the power trigger
1. Put the power trigger (C) into the handle.
2. Put the handle stop (A) and the spring (B) into the
handle.
3. Assemble the rear handle. See
rear handle on page 18 .
4. Assemble the right chassis half and the front handle.
To remove the front handle on page 9 and To
See
disassemble the chassis on page 8 .

5.6 Gears

5.6.1 To remove the gear housing and the motor
To
from the chassis
1. Disassemble the front handle and the right chassis
To remove the front handle on page 9 and
half. See
To disassemble the chassis on page 8 .
2. Disconnect the motor plug from the control unit.
C
B
To assemble the
Repair instructions - 11
A