ELECTRICAL SYSTEM
2.7.4
Removing brushes, brush holder, yoke and
armature
While lifting the two brushes, remove the yoke and brush
holder assembly. Then, pull out the armature.
2.7.5
Removing ball bearing
Remove the bearings from both ends of the armature using a
puller.
2.7.6
Removing cover set
Remove the cover, and pull out the snap ring and the
washer.
12-28
Brush
Yoke
Removing brushes, brush holder, yoke and
armature
Rear bearin
Front bearing
Removing ball bearings
Snap ring
Removing cover
Brush holder
Armature
Armature
Washer
Cover