Disconnecting Tie Rod From Control Rack; Removing Governor Shaft And Speed Control Lever - Mitsubishi L Series Service Manual

FUEL SYSTEM
1.3.1

Disconnecting tie rod from control rack

(1) Remove the tie rod cover.
(2) Remove the tie rod clip and disconnect the tie rod from
the control rack.
1.3.2 Removing governor shaft and speed con-
trol lever
(1) Remove the sealing cap from the side of the gear case.
(2) Pull out the grooved pin A.
(3) Remove the governor shaft, and remove tension lever
and governor lever.
(4) Remove the governor spring lever.
(5) Remove the grooved pin B and remove speed control
lever.
(6) Remove the governor cover.
8-6
Tie rod clip
Tie rod
Control rack
Disconnecting tie rod from control rack
Speed control
lever Governor shaft cover
Grooved pin B
Governor spring lever
Governor lever
Grooved pin A
Removing governor shaft and
speed control lever
Tension lever
Sealing cap
Governor shaft
Gear case