Installing Yoke And Armature; Installing Brush Holder And Brush Assembly; Installing Rear Bracket; Installing Magnetic Switch - Mitsubishi L Series Service Manual

2.5.4

Installing yoke and armature

(1) Install the planetary gears on the gear shaft.
(2) Install the packing on the internal gear.
(3) Install the plate and packing.
(4) Install the yoke on the front bracket.
(5) Apply grease to the armature shaft end and install a ball
on it.
(6) Install the armature.
Note: The adjustment of play in the axial direction of the
armature shaft is not necessary.
2.5.5

Installing brush holder and brush assembly

Attach the socket to the commutator of the armature.
While sliding the brushes on the socket, install the brush
holder and brush assembly on the armature.
2.5.6

Installing rear bracket

Install the rear bracket to the yoke, and tighten the through
bolt and the brush holder screws.
2.5.7

Installing magnetic switch

(1) Install the magnetic switch and tighten the screws.
(2) Connect the lead to the terminal M and secure it with
the fixing nut.
Packing
Plate
Ball
Planetary gear
Installing yoke and armature
Socket
Installing brush holder and brush assembly
Rear bracket
Installing rear bracket
Magnet switch
4.1 to 7.6 N m
{0.42 to 0.77 kgf m}
[3 to 6 lbf ft]
Installing magnetic switch
ELECTRICAL SYSTEM
Armature
Yoke
Packing
Brush holder
Brush assembly
Screw
2.4 to 4.4 N m
{0.24 to 0.45 kgf m}
[2 to 3 lbf ft]
Through bolt
4.4 to 7.1 N m
{0.45 to 0.72 kgf m}
[3 to 5 lbf ft]
Terminal M
8.8 to 12.7 N m
{0.90 to 1.30 kgf m}
[7 to 9 lbf ft]
12-21