Separating Front Bracket From Stator; Removing Pulley; Removing Rear Bearing; Removing Front Bearing - Mitsubishi L Series Service Manual

ELECTRICAL SYSTEM

2.10.1 Separating front bracket from stator

Do not disassemble the alternator unless the repair is
necessary.
Do not insert the screwdrivers too deep, as it can dam-
age the stator.
(1) Remove the through bolts.
(2) With two flat-head screwdrivers inserted between the
front bracket and stator, pry them apart.

2.10.2 Removing pulley

When setting the rotor in a vise, be sure to hold the
base of the rotor claw. Do not hold the rotor claw, as it
causes damage to the claw.
(1) Apply a cloth to the rotor and set it in a vise.
(2) Remove the pulley nut and then pull out the pulley.

2.10.3 Removing rear bearing

Remove the rear bearing from the rotor using a bearing
puller.

2.10.4 Removing front bearing

Remove the screw, and then remove the bearing retainer and
front bearing from the front bracket.
12-40
Stator core
Separating front bracket from stator
Removing pulley
Rotor
Rear bearing
Removing rear bearing
Screw Front bearing
Removing front bearing
Rear bracket
Front bracket
Pulley
Front bracket
Rotor
Front
bracket
Bearing retainer