Installing Speed Control Lever And Governor Shaft; Installing Relief Valve; Installing Oil Pump - Mitsubishi L Series Service Manual

REASSEMBLY OF BASIC ENGINE
2.8 Installing speed control lever and
governor shaft
(1) Insert the governor shaft into the gear case with the
governor lever and the tension lever positioned in
place.
(2) Drive the grooved pin into the gear case.
(3) Drive new sealing cap into the gear case.
(4) Thoroughly apply Alvania Grease #2 or #3 to the
governor shaft cover.
(5) Install new O-ring on the speed control lever and insert
it into the gear case through the governor shaft.
(6) Drive the grooved pin into the gear case.
(7) Install the governor spring lever.
Note: Install the governor spring lever to the speed control
lever with the minimum assembling angle.

2.9 Installing relief valve

Insert the relief plunger and relief spring into the gear case,
and tighten the plug to the specified torque.

2.10 Installing oil pump

Install the oil pump inner gear, oil pump outer gear and oil
pump housing to the gear case, and tighten the bolts to the
specified torque.
7-12
Speed control
Governor shaft cover
lever
Grooved pin B
Governor spring lever
Governor lever
Grooved pin A
Installing speed control lever and
governor shaft
Governor lever
Tension
lever
Sealing cap
Gear case
Reassembling speed control lever
Relief plunger
Gear case
Installing relief valve
Oil pump inner gear
7.8 to 9.8 N m
{0.8 to 1.0 kgf m}
[5.8 to 7.2 lbf ft]
Gear case
Installing oil pump
Tension lever
Sealing cap
Governor shaft
Gear case
Protrusion
approx. 2 mm
Grooved pin
[0.08 in.]
Section AA
39.2 to 49.0 N m
Plug
{4.0 to 5.0 kgf m}
[28.9 to 36.2 lbf ft]
Relief spring
Oil pump housing
Oil pump outer gear