Moving The Library From A Desktop To A Rack; Removing Library From A Desktop - IBM TS2900 Setup, Operator, And Service Manual

Moving the Library from a Desktop to a Rack

This procedure is used to relocate a library mounted on the desktop using the
deskside kit to a rack using the rack mount kit.

Removing Library from a Desktop

1. Take the library offline.
2. From the Web User Interface, select Configure Library → Save/Restore → Save
3. After saving your configuration, log out of the Web User Interface and close the
4. From the Operator Panel, select Unlock Magazine, and press Enter to remove the
5. From the Operator Panel, select Move to Ship Position, and press Enter. This
6. From the Operator Panel top menu, select Logoff, and press Enter.
7. On the rear panel of the library:
8. Insert and tighten the Accessor locking screw
Figure 8-12. Insert Accessor locking screw
Note: If the library is processing queued requests, wait for the library to finish
the current library task.
to save the current library configuration to a file for easy restoration.
Internet browser.
cartridge magazine (if necessary).
Note: If the cartridge magazine fails to unlock in response to the Unlock
Magazine command from the Operator Panel, you can unlock the
magazine manually. See "Unlocking the Cartridge Magazine Manually"
on page 8-1.
moves the Accessor assembly to a safe position ready for moving the library.
Note: If the library is to be transported any distance, this move is necessary to
park the Accessor in the position where it can be secured by the Accessor
locking screw.
a. Power OFF the library by toggling the power supply switch to the OFF (O)
position.
b. Disconnect the power cable from the library power supply.
c. Disconnect the Ethernet cable.
d. Disconnect the SAS host interface cable.
.
1
1
Chapter 8. Removal and Replacement Procedures
8-7