Power Cords - IBM TS2900 Setup, Operator, And Service Manual

CAUTION:
Removing components from the upper positions in the rack cabinet improves rack
stability during relocation. Follow these general guidelines whenever you relocate
a populated rack cabinet within a room or building:
• Reduce the weight of the rack cabinet by removing equipment starting at the top
• If the rack cabinet you are relocating is part of a suite of rack cabinets, detach the
• Inspect the route that you plan to take to eliminate potential hazards.
• Verify that the route that you choose can support the weight of the loaded rack
• Verify that all door openings are at least 762 x 2032 mm (30 x 80 in.).
• Ensure that all devices, shelves, drawers, doors, and cables are secure.
• Ensure that the four leveling pads are raised to their highest position.
• Ensure that there is no stabilizer bracket installed on the rack cabinet during
• Do not use a ramp inclined at more than ten degrees.
• Once the rack cabinet is in the new location, do the following:
• If a long distance relocation is required, restore the rack cabinet to the
(R002)

Power Cords

To avoid electrical shock, a power cord with a grounded attachment plug has been
provided. Use only properly grounded outlets.
All power cords use an appliance coupler that complies with the International
Electrotechnical Commission (IEC) Standard 320, Sheet C13.
If the power cord that you receive does not match your receptacle, contact your local
dealer.
Power cords used in the United States and Canada are listed by Underwriter's
Laboratories (UL), are certified by the Canadian Standards Association (CSA), and
comply with the plug standards of the National Electrical Manufacturers Association
(NEMA).
xvi
TS2900 Tape Autoloader Setup, Operator, and Service Guide
of the rack cabinet. When possible, restore the rack cabinet to the configuration
of the rack cabinet as you received it. If this configuration is not known, you
must do the following:
– Remove all devices in the 32U position and above.
– Ensure that the heaviest devices are installed in the bottom of the rack
cabinet.
– Ensure that there are no empty U-levels between devices installed in the rack
cabinet below the 32U level.
rack cabinet from the suite.
cabinet. Refer to the documentation that comes with your rack cabinet for the
weight of a loaded rack cabinet.
movement.
– Lower the four leveling pads.
– Install stabilizer brackets on the rack cabinet.
– If you removed any devices from the rack cabinet, repopulate the rack cabinet
from the lowest position to the highest position.
configuration of the rack cabinet as you received it. Pack the rack cabinet in the
original packaging material, or equivalent. Also lower the leveling pads to raise
the casters off of the pallet and bolt the rack cabinet to the pallet.