Table 3-4. Default library configuration settings (continued)
Advanced encryption settings
NTP server
NTP server address
Time zone (GMT)
Auto adjustment by PC
SMTP (mail) settings
SNMP (trap) settings
Static library network settings must be entered using the Operator Panel before the
library can be accessed remotely using the Web User Interface. If your system is
serviced by a DHCP (Dynamic Host Configuration Protocol) server, the network
parameters will be automatically set. Once remote access has been established, you
can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to "Configuring
Your Library using the Operator Panel" on page 3-28.
Configuring Your Library using the Web User Interface
If you choose to use the Web User Interface to configure your library, first enter your
library network settings using the Operator Panel (see "Configuring Network
Settings" on page 3-29).
To configure your library using the Web User Interface, complete the following
procedures:
1. Install Java 1.5.0 or higher on your host computer. Download the latest version of
3-16
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Configuration Item
Mail server address
Mail event
Community
Trap event
SNMPv3 engine ID
the Java Runtime Environment (JRE) for your platform from
http://www.java.com/.
D
T
ATE AND
IME
N
OTIFICATIONS
(Set by library firmware)
Default Setting
(None)
0.0.0.0
+00:00
Every 1 minute
0.0.0.0
Error events enabled
Public
Error events enabled