Figure 91. Releasing the internal M.2 boot module from the motherboard
2. Touching only the outside edges of the internal M.2 boot module, lift the end of the internal M.2 boot module to a slight
angle, and then remove it from the slot on the motherboard.
Figure 92. Removing the internal M.2 boot module
Install the internal M.2 boot module
Steps
1. Touching only the outside edges of the internal M.2 boot module, place the internal M.2 boot module into the slot on the
motherboard.
NOTE:
The side of the internal M.2 boot module with the barcodes should be facing up.
Figure 93. Placing the internal M.2 boot module
2. Connect the blue pull tab to the blue connector on the motherboard.
Base enclosure service procedures
79