Advertisement
Operation
The fireplace can be operated with the multi–function IR remote control or from
the touchscreen controls on the top-right of the front glass.
Once the fireplace is turned on the digital display and the control icons on the
front glass will illuminate. If no button or icon is pressed within 10 seconds, the
fireplace controls will deactivate by the digital display turning off first and then the
icons. To reactivate the controls press any button on the remote or touch any icon
on the front glass.
7
1. Power ON/OFF
2. Flame Control
3. Heat ON/OFF
4. Timer
5. Ember Bed
6. Level Selection
7. Digital Display
!
The heater on your fireplace may emit a slight, harmless odour when first
NOTE:
used. This odour is a normal condition caused by initial heating of internal heater
parts and will not occur again.
CUTOFF SWITCH
!
There is a safety temperature cutoff switch (cutout) inside the heater. If
NOTE:
the heater overheats, the cutout will shut off the supply power.
It can be reset by unplugging the unit and waiting 5 minutes before plugging
the unit back on.
If you need to continuously reset the heater, unplug the unit and call
CAUTION:
technical service at 1300 556 816 for Australia and
09 274 8265 for New Zealand.
1
2
3
4
5
6
Remote
17
Advertisement
