Advertisement
Maintenance
• Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use
brass polish or household cleaners as these products will damage the metal
trim.
• The motors used on the fan and the flame generator assembly are pre-
lubricated for extended bearing life and require no further lubrication. However,
periodic cleaning/vacuuming of the fan/heater and air intake/output vents
is recommended. The heater should be cleaned and inspected regularly,
depending on conditions, and at least at yearly intervals.
Any electrical repairs of this unit should be carried out by a
WARNING:
licensed electrician in accordance with national and local codes.
Disconnect power by unplugging the power and allowing heater to
WARNING:
cool before attempting any maintenance or cleaning to reduce the risk of fire,
electric shock, or injury.
!
When the heater is not in use, the heater should be stored in a dry
NOTE:
location, away from possible damage. The power cord should be stored
properly to avoid contact with hot or sharp objects.
Remote Control
The battery compartment is located on the back end of the remote control.
1. Press and slide the battery cover open.
2. Insert two 1.5V (AAA) batteries (included) ensuring they are installed correctly
with regard to the polarities (+ and -) marked on the inside of the battery
compartment.
3. Replace the battery cover.
!
The battery should be removed if the product is to be left unused for a
NOTE:
long time.
Replacing the Remote Control Batteries
When replacing the batteries, replace both batteries at the same time with new
batteries of the correct type.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nicad, Nimh, etc)
batteries.
20
Advertisement
