Replacing A Summit 1100 W Dc Power Supply - Extreme Networks ExtremeSwitching X440-G2 Series Hardware Installation Manual

6 Insert the connector into the slot on the power supply.
Figure 238: Inserting the Connector into the Power Supply
7 Connect the cables to the DC source voltage, using hardware appropriate to the installation site and
following local and national electrical codes.
8 Energize the DC circuit.

Replacing a Summit 1100 W DC Power Supply

The ExtremeSwitching X690 and X870 series switches accommodate one or two Summit 1100 W DC
power supply units (PSUs) with either front-to-back or back-to-front airflow.
Note
The X690 and X870 models also can accommodate one or two 770 W AC PSUs. For
information on replacing those units, see
page 272. Bear in mind that you cannot combine power supplies of different wattages in the
same switch.
You need the following tools and materials to replace an 1100 W DC power supply:
•
#1 Phillips screwdriver
•
Torque screwdriver and wrench or torque driver with attachments for tightening screws and nuts
•
Thermal protective gloves (required for removal of a power supply)
ExtremeSwitching and Summit Switches: Hardware Installation Guide
Replacing DC Power Supplies
Replacing a Summit 770 W AC Power Supply on
299