Extreme Networks ExtremeSwitching X440-G2 Series Hardware Installation Manual page 246

Connecting the RPS Cable and AC Power Cord
Attention
When performing this task, observe all of the precautions listen in
Installing Power Supplies
The redundant power supply is connected to a switch using a 1-meter RPS cable.
To connect a redundant power supply, proceed as follows:
Note
No change in switch configuration is necessary for this installation.
1 Connect one end of the RPS cable to the redundant power supply connector at the rear of the RPS.
Then connect the other end of the cable to the redundant power supply connector on the switch.
See the following figures.
Figure 192: Power Connectors on STK-RPS-150PS (rear view)
1 = Redundant power supply connector
Figure 193: RPS and AC Power Cord Connections
1 = Switch
2 = High speed RPS cable (1 meter)
3 = RPS Redundant Power Supply
connector
ExtremeSwitching and Summit Switches: Hardware Installation Guide
on page 224.
4 = Switch Redundant Power Supply connector (location varies
depending upon switch)
5 = AC power cord (type varies depending on country)
6 = AC power outlet with ground connection (type varies
depending on country)
Installing External Power Supplies
Safety Considerations for
2 = AC power connector
246