Installing An Rps-150Xt Redundant Power Supply - Extreme Networks ExtremeSwitching X440-G2 Series Hardware Installation Manual

3 Open the clip and slip it over the barrel of the connector.
Figure 181: Attaching the Power Cord Retainer on the 750 W AC Power Supply
4 Snap the clip firmly around the connector.
5 Connect the other end of the power cord to an AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the AC power supply.
Caution
Make sure that the AC power supply circuit is not overloaded. Use proper overcurrent
protection, such as a circuit breaker, to prevent overcurrent conditions.

Installing an RPS-150XT Redundant Power Supply

You can install the RPS-150XT power supply on a flat surface or in a 19-inch rack in the three-slot
modular shelf (STK-RPS-1005CH3), which is available for purchase separately.
Caution
Observe all ESD precautions when handling sensitive electronic equipment.
Only qualified personnel should install redundant power supply (RPS) units.
Unpacking the RPS-150XT
To prevent electrostatic damage, attach an electrostatic discharge (ESD) wrist strap to your wrist before
handling the RPS-150XT.
ExtremeSwitching and Summit Switches: Hardware Installation Guide
Installing External Power Supplies
233