Kenwood NX-220 Service Manual page 15

DISASSEMBLY FOR REPAIR /
Note: Refer to page 10 for how to install the channel se-
lector knob and knob spring.
■ Connection place of the antenna hot pin and
antenna terminal
An antenna hot pin is connected with the antenna termi-
nal at the position shown in the fi gure.
Confi rm that the antenna hot pin has fi rmly come in con-
tact with the terminal when the TX-RX unit is tightened
with the screw.
Additionally, refer to the following fi gures for the connec-
tion place of the antenna terminal and the TX-RX unit.
■ Align the SP/MIC lead wire
Align the SP/MIC lead wire as shown in the fi gure. It is
possible to fi x temporarily by interweaving the two lead
wires between the tabs (tab A and tab B) and boss of the
speaker holder.
TX-RX unit / 收发单元
Antenna
terminal
Antenna hot pin
天线端子
天线棒
维修拆卸
注意 ： 有关信道选择旋钮和旋钮弹簧的安装方法，请参阅
第 10 页。
■天线棒和天线端子的连接位置
在图示的位置连接天线棒和天线端子。
用螺钉拧紧收发单元后，确认天线棒已与天线端子牢固接
触。
此外，有关天线端子与收发单元的连接位置，请参阅下图。
Antenna terminal
天线端子
■对准 SP/MIC 导线
对准 SP/MIC 导线，如图所示。可将扣环 ( 扣环 A 和扣环 B)
与扬声器托架凸起部之间的导线暂时固定起来。
B
A
NX-220
15