Kenwood NX-220 Service Manual page 12

NX-220
■ Removing the speaker holder
There is a space of approximately 1mm (0.04 inch) be-
tween the center part of the front glass of the speaker
holder and the surface of the Display unit. Set your fi nger
on the space in the center part of the front glass, then lift
and remove it.
■ Removing the TOP packing
1. Pull the TOP packing to the left to remove the packing
that is fi t into the left groove of the chassis. q
2. Pull the TOP packing to the right to remove the packing
that is fi t into the right groove of the chassis. w
3. Pull the TOP packing to the center to remove the packing
that is fi t into the center groove of the chassis. e
4. Remove the TOP packing. r
Note:
Remove the packing slowly, as the packing of the selec-
tor part might overset when the TOP packing is removed.
If the packing is turned over, return it to the normal posi-
tion using a soft tipped item (e.g., your fi nger).
12
DISASSEMBLY FOR REPAIR /
维修拆卸
■拆下扬声器托架
在扬声器托架前玻璃的中间部分和显示单元表面之间存在
约 1m m 的空隙。将手指置于前玻璃中间部分的空隙处，然
后将其提起并拆下。
Speaker holder / 扬声器托架
Display unit / 显示单元
■拆下顶盖
1. 将顶盖拉至左侧，拆下装在底座左侧凹槽内的盖。①
2. 将顶盖拉至右侧，拆下装在底座右侧凹槽内的盖。②
3. 将顶盖拉至中央，拆下装在底座中央凹槽内的盖。③
4. 拆下顶盖。④
注意 ：
慢慢拆下密封件，因为在拆下顶盖时，选择器部分的密封
件可能会翻转。 如果密封件翻转， 可用尖形的软物 ( 如手指 )
将其恢复到正常的位置。