Adding Printers In Windows 2000 / Xp / 2003 Using The Microsoft Lpr Monitor - Axis 5570e User Manual

Adding Printers in Windows

Adding Printers in Windows 2000 / XP / 2003 using the Microsoft LPR Monitor

Note:
Basic Setup
Preparing for
LPR Printing
Installing an LPR
printer
Windows XP:
Windows 2000:
72
This section describes how to set up a Windows 2000/XP/2003 server for
LPR printing over the TCP/IP protocol, using the built-in Microsoft LPR
Monitor i.e. Print Services for UNIX.
See "Alternative Method for LPR Printing" on page 73 for instructions on how
to set up printing over LPR without installing Print Services for Unix.
If you have not already done so, you should perform the TCP/IP basic
setup procedures prior to installing a printer for LPR printing.
Follow the following steps to prepare for LPR printing:
1. Open the Control Panel.
2. Click Add/Remove Programs.
3. Click Add/Remove Windows Components.
4. Check Other Network File and Print Services and click Details.
5. Check Print Services for Unix and click OK.
6. Click Next and Finish.
7. Close Add/Remove Programs and the Control Panel.
Follow the instructions below to use the standard Windows method for
installing an LPR printer in Windows 2000/XP/2003:
1. Go to Start | Printers and Faxes and click the Add a Printer icon to start
the Add Printer Wizard. Click Next.
1. Go to Start | Settings | Printers and click the Add Printer icon to start
the Add Printer Wizard. Click Next.
2. Select the appropriate radio button: Local Printer. Click Next.
3. Click the Create a new port radio button and select LPR Port from the list.
Click Next.
AXIS 5570e / AXIS 5670e User's Manual