Updating Parameters - Axis 5570e User Manual

SNA Parameter Overview

Updating parameters

Syntax:
174
Parameter
Description - Axxxxxxx, where "xxxxxxx" is the last 7 characters of the Axis Network Print Server
serial number, in reverse order, e.g.
if s.no. =
00 40 8C 1B 06 D4 the default LU Name =
A4D60B1C.
This will be the name of the APPC device and controller
created during auto-configuration
CP_NAME
(AXIS 570 only)
Description - Axxxxxxx, where "xxxxxxx" is the last seven characters of the Print Server serial
number, in reverse order, i.e. a print server with serial number 00 40 8C 1B 06 D4 will have the
default CP Name A4D60B1C. This will be the name of the APPC controller created during auto-
configuration.
H1_NW_NAME
H1_LU_NAME
This is most easily done from the internal Web pages of your Axis
Network Print Server. To set the parameters using a Web browser, you
first need to assign an IP address to the Axis Network Print Server. For
instructions on how to do this, refer to "Setting the IP Address" on page
16.
Alternatively, you can update the parameters via FTP, TFTP or by using
extended IBM printer emulation.
Using extended IBM printer emulation means setting up the Axis Network
Print Server by printing a file containing extended IBM emulation
commands to it after you have established communication with your IBM
host. The configuration is started by inserting the sequence
your text. To protect your settings, a password must be provided. By
default, the password is
directly using the syntax shown below:
<Parameter name> = <value> [, <value>];
When all parameters have been set the
permanently. The
%CONFIG-
to maintain backward compatibility, some parameters must be preceded
by a command. See also The Parameter List, on page 216.
%CONFIG++
To set the parameters to their default values, enter the following in your
document and print it.
Name Default
Control Point Name Axxxxxxx
Host Network Name APPN
Host LU Name
DEFAULT
. You may then set the parameter values
pass
command saves the settings
SAVE
command resumes normal printing. In order
AXIS 5570e / AXIS 5670e User's Manual
Emulation
5494 only
5494 only.
5494 only
in
%CONFIG+