Adding Printers In Windows 2000/Windows Xp Using The Microsoft Lpr Monitor - Axis 5500 User Manual

Adding Printers in Windows 2000/Windows XP using the Microsoft LPR Monitor

Note:
Basic Setup
Preparing for
LPR Printing
AXIS 5500 / AXIS 5550 User's Manual
4. Type the print server's name or IP address in the field Name or address of
server providing lpr (Example: 10.13.6.198). Then enter which port to use in
the field Name of printer or print queue on that server according to the table
below (Example: USB1). Click OK and then Close:
Ports available
AXIS 5500
AXIS 5550
5. The added print server will now appear in the Available Ports list. Click Next,
choose a driver and finish the installation as usual.
This section describes how to set up a Windows 2000/XP server for LPR printing
over the TCP/IP protocol, using the built-in Microsoft LPR Monitor i.e. Print
Services for UNIX.
See "Alternative Method for LPR Printing" on page 30 for instructions on
how to set up printing over LPR without installing Print Services for Unix.
If you have not already done so, you should perform the TCP/IP basic setup
procedures prior to installing a printer for LPR printing.
Follow the following steps to prepare for LPR printing:
1. Open the Control Panel.
2. Click Add/Remove Programs.
3. Click Add/Remove Windows Components.
4. Check Other Network File and Print Services and click Details.
5. Check Print Services for Unix and click OK.
6. Click Next and Finish.
7. Close Add/Remove Programs and the Control Panel.
Adding Printers in Windows
USB port Parallel port
USB1 —
USB1 LPT1
29