Verifying The Communication Link (As/400) - Axis 5570e User Manual

AXIS 5570e and AXIS 5670e User's Guide

Verifying the Communication Link (AS/400)

Follow the instructions below to verify the communication to the AXIS 5570e/AXIS 5670e:
1. Type WRKCFGSTS *DEV AXISPR1 on the AS/400 command line and press Enter. The
previously created printer device will be displayed. The status of the printer device should be
.
VARIED OFF
2. Vary on the printer device by typing
3. Press F5 to refresh the display. The printer device should now be
4. Start the printer writer by typing STRPRTWTR AXISPR1 on the AS/400 command line.
Press Enter.
5. Press F5 to refresh the display. The printer device should now be
6. Direct a printout to this printer device. A successful printout verifies the communication link
between the AS/400 and the AXIS 5570e/AXIS 5670e.
Note:
If the setup fails, please refer to the troubleshooting section in the AXIS 5570e/AXIS 5670e User's Manual, on
www.axis.com
Proceed to Print Server Management and Configuration on page 56 for information on supported
management and configuration tools.
field. Press Enter.
in the
1 Opt
.
VARIED ON
.
ACTIVE/WRITER
29